ADDRESSER SOFTWARE

Ultrasonic provides free software, Addresser, as well as an interconnect cable to handle all data transfers to and from the Portable and a Flow Meter computer.The cable will be connected between the Mini-USB mating receptacle on the side of the Portable, and the USB Port of your computer or laptop. The Ultrasonic flow meter can be set up for up to 16 Calibrations or Configurations that initially default to Channel A, Channel B, Channel C, etc. Prior to using the Flow Meter, those Channels can be renamed (up to 8 characters) using the software to clearly describe the Channel's calibration parameters (i.e., NATGAS2"). However, the software will not be required to select the Channels upon use, that can be done with the UP and DOWN command buttons (see page 2). For those Users who intend to cover a large number of pipes (for example, conducting an energy audit in a large factory), the User can switch the Ultrasonic from CHANNEL Navigation Mode to TAG ID Navigation Mode (see below). In this mode, up to 99 specific TAG IDs (up to 8 characters) can be assigned using the software.Once TAG IDs are assigned, such as BLDG3NG2 (i.e., the 2nd Natural Gas pipe in Bldg 3), those unique Tags can be associated with appropriate Calibration Channels either using the Addresser software or a screen selection on the Ultrasonic called RE-MAP. This ability to associate unique TAG IDs with a specific Channel, allows the User to apply the proper Calibration and settings for each TAG ID (pipe), so the measurements for that location will be accurate.